Plug in the power cords of the TV and the VCR | Magnavox VRC602M

Hookups Without a Cable Box/Direct Broadcast System (cont’d) 7

3

Connect the supplied black RF coaxial cable to the OUT Jack on the back of the VCR and to the ANTENNA IN Jack on the TV. (You may use either a snap-on

type (supplied) or screw-on type of coaxial cable, whichever you prefer.)

4

75 ANT / CABLE

ANTENNA IN Jack

(on back of TV)

example only

RF coaxial cable

Plug in the power cords of the TV and the VCR.

5

Set the CH3/CH4 switch on the back of the VCR to CH3 or CH4, whichever channel is not used or least used in your area. Set the TV to the same channel. For example, when playing a tape, if the CH3/CH4 switch is set to CH3, the TV should be on channel 03.

CH	4
or
CH	3

CH3 / CH4

Switch

CH3 CH4

6

You are ready to turn on the VCR. Please go to page 11 before turning on the VCR.

Image 7

Magnavox VRC602M Hookups Without a Cable Box/Direct Broadcast System cont’d, Plug in the power cords of the TV and the VCR

Contents

VCR For Customer Use Warranty Verification Declaration of Conformity FeaturesSafety Precautions Introduction Table of Contents VCR maintenance Putting Batteries in the Remote ControlBattery Safety Using the Remote Control Disconnect the antenna or cable from your TV Hookups Without a Cable Box/Direct Broadcast System Hookups Without a Cable Box/Direct Broadcast System cont’d Plug in the power cords of the TV and the VCR Connections Hookups With a Cable Box/Direct Broadcast SystemRecording/Viewing Any Channel Recording One Channel/Watching Another Hookups With a Cable Box/Direct Broadcast System cont’d Hookups with a Stereo TV Press the Menu button. The display shown below will appear Turning on Your VCR Press the VCR button, then press the Menu button Automatic Channel Setup Adding/Deleting Channels Automatic Channel Setup cont’d Press the STATUS/EXIT button once or twice to exit Reviewing Memorized Channels Enter a 0 before a single-digit number Setting the Clock Press the VCR button, then press the Menu button Daylight-Savings Time Language Selection 2TV code Find your Setting the Remote to Operate a TV 2code Find your Cable BOX Codes Remote Control Buttons TV Button CHannel o/p Buttons If you select Status OFF On-Screen Status DisplaysIf you select Status ON, then select Counter only on If you select Status ON, then select Counter only OFF VCR Light VCR Display PanelCassette Compartment RECord Light Front Panel Rear Panel VHS Quasi Play Back Sqpb Playing Insert a tape with its record tab intact in the VCR Recording Recording One Channel/Watching Another One-Touch Recording Daily Timer Recording Timer Recording cont’d Tape Speeds Timer Recording cont’d Checking or Cancelling Timer Recordings Rerecording Tape Duplication Press the PLAY/o button or the STOP/p button to select Repeat PlayPress the F.FWD/B button so that on appears beside Real-Time Counter Memory Clear button to reset the real-time counter to zeroWhile the status display is on the screen, press Press the VCR button, then press the Time Search but- ton Time Search Viewing a Still Picture Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLP Automatic Operation Features Understanding On-Screen Displays Multi-Channel Television Sound System Multi-Channel Television Sound System cont’d Please see additional notes on Hi-Fi Stereo Sound System Blue Background Helpful Hints Helpful Hints cont’d Renewed Specifications Glossary / SpecificationsGlossary Automatic Index Supplied Accessories