Magnavox ZC352MW8 owner manual To stop the timer recording in process

TIMER RECORDING

Checking, canceling, or correcting the timer programming information

1)Press [STANDBY-ON y].

2)Press [TIMER].

3)Check the information on the list you will need.

Timer Programming

Date	Start	End	CH	Mode
1. JAN/01 12:57AM		1:57PM	8	HQ

2.---

3.---

4.---

5.---

6.---

7.---

8.---

4)To clear the timer programming:

Use [K / L] to select the program, then press [CLEAR].

To correct the timer programming:

Use [K / L] to select your desired program, then press [OK].

Next, correct the timer programming by using [K / L / { / B]. Finally, press [OK] again.

5)Press [TIMER] to exit.

6)Press [STANDBY-ON y] to return to the timer standby mode.

To stop the timer recording in process

Press [STOP C] on the front panel of the unit. [STOP C] on the remote control is not effective.

Note

•Press [TIMER] to check the timer recording in progress.

When the timer recording is proceeding, that program will be highlighted with red. In this case, you cannot select any other program.

If the timer program did not complete correctly, the error number appears in the timer pro- gramming list.

Timer Programming

	Date	Start	End	CH	Mode
* JAN/01 12:57AM			1:57PM	8	E22
2.	---
3.	---
4.	---
5.	---
6.	---
7.	---
8.	---

Press [CLEAR] to erase the selected program.

Each error number means:

E1-22	Recording error other	E41	Power failed
E37-39	than below
E24	Unrecordable disc	E42	No disc when
			recording
E25-26	Copy prohibited	E43	Already 49 titles
	program		recorded
E29	Disc protected	E44	Already 254 chapters
			recorded
E30	Disc full	E45	Copy prohibited
			program
E35	PCA full	E46	It is impossible to
E36	Already finalized		record additionally
			on a disc recorded
	video format disc
			by other units when
E40	Some portion has
			setting “Replace Disc
	not been recorded		Menu” to “OFF”.

because of program overlapping. Recording did not start at the start time.

•E23, E27, E28, E31, E32, E33 and E34 are not displayed.

•A program with the error number is grayed and asterisked in the timer programming list.

•Once the timer programming list with error line(s) is displayed, or after canceling and setting again the timer standby mode, the program line(s) with error will be cleared.

Introduction Connections Basic Setup Recording Playback

Editing Function Setup Others

Español

EN 37