Majestic Appliances installation instructions Important Information, UV36 Vent-FreeFirebox

20007446

Children and adults should be alerted to the hazard of high surface temperature and should stay away to avoid burns or clothing ignition.

manufacturer.

local codes.

any gas control which has been under water.

fuel level in the propane tank is below 1/4 full.

rooms or bathrooms.

CODE, ANSI Z223/NFPA 54, latest edition.

After servicing, always check for leaks.

person or gas appliance installer.

draperies.

•

•

NOTES

OWNER:

reference.

owner.

UV36 Vent-Free Firebox

Important Information

INSTALLER: Please leave these instructions with the	To avoid irreparable damage to the appliance or personal in-
	jury; matches, paper, garbage or any other material must not
Please retain these instructions for future	be placed or thrown on top of the logs or into the flames.
IMPORTANT: READ THESE INSTRUCTIONS CARE-	To avoid personal injury, do not touch hot surfaces when
	the appliance is operating.
FULLY BEFORE OPERATING.	Close supervision is necessary when the appliance is being
WARNING: Any change to this heater or its con-	operated near children.
trols can be dangerous.	This appliance is intended to be used only for supplemental
This heater shall not be installed in a confined	heat. Do not use it routinely as a primary heat source.
space or unusually tight construction unless provi-	Continuous operation could produce excessive humidity de-
	pending on construction characteristics and outdoor tempera-
sions are provided fro adequate combustion and
	tures (below 20°F). Over time, this could cause condensation
ventilation air.
	to form and damage wall structures and exterior paint.
• Due to high temperatures, the appliance should be	WARNING: Do not install glass doors on this fire-
	place.
located out of traffic and away from furniture and
	WARNING: If the area in which the heater may be
Installation and repair must be done by a qualified service	operated is smaller than that defined as an uncon-
	fined space or if the building is of unusually tight
The appliance must be inspected before use and at least	construction, provide adequate combustion and
annually by a professional service person. More frequent	ventilation air by one of the methods described in
cleaning may be required due to excessive lint from	the National Fuel Gas code, ANSI Z223.1/NFPA 54,
carpeting, bedding material, dust and pet hair, etc. It is	section 5.3 or applicable local codes.
important that the control compartment, burners and cir-
culating air passageways of the appliance be kept clean.	WARNING: Do not allow fans to blow directly into
• DO NOT place clothing or other flammable material on	the fireplace. Avoid any drafts that alter burner
	flame patterns.
or near the appliance.
	WARNING: Do not use a blower insert, heat ex-
• The installation must conform with local codes or, in the
	changer insert or other accessory not approved
absence of local codes, with the NATIONAL FUEL GAS
	for use with this heater.
• Any safety screen or guard removed for servicing an appli-
	WARNING: During manufacturing, fabricating
ance must be replaced prior to operating the heater.	and shipping, various components of this appli-
• DO NOT use this heater in recreational vehicles, bed-	ance are treated with certain oils, films or bonding
	agents. These chemicals are not harmful but may
• If this is the ONLY gas appliance, we recommend a	produce annoying smoke and smells as they are
	burned off during the initial operation of the appli-
minimum 200 pound cylinder with a fill gauge. Use
	ance, possibly causing headaches and eye/lung
of a 100 pound cylinder is not recommended. Other
	irritation. This is a normal and temporary occur-
household gas appliances may require the tank size
to be larger. Do not operate the vent-free heater if the	rence.
• DO NOT use this heater if any part of it has been under	The National Fuel Gas Code, ANSI Z223.1/NFPA
	54 defines a confined space as a space whose
water. Immediately call a qualified technician to inspect the
	volume is less than 50 cubic feet per 1,000 Btu
appliance and replace any part of the control system and
	per hour (4.8m3 per kw) of the aggregate input
• Check local, state or city codes to determine if un-	rating of all appliances installed in that space and
	an unconfined space as a space whose volume is
vented heaters are permitted.
	not less than 50 cubic feet per 1,000 Btu per hour
• This appliance may be installed in an after-market* manu-
	(4.8 m3 per kw) of the aggregate input rating of all
factured “mobile” home where not prohibited by state or	appliances installed in that space. Rooms com-
*After-market: Completion of sale, not for purpose of re-sale from the	municating directly with the space in which the
	appliances are installed, through openings not
	furnished with doors, are considered a part of the
	unconfined space.

3