Installing or removing battery cartridge

0 Always switch off the tool before insertion or removal of the battery cartridge.

0 To remove the battery cartridge, pull out the set plate on the tool and grasp both sides of the cartridge while withdrawing it from the tool.

 

0 To insert the battery cartridge, align the

 

tongue on the battery cartridge with the

 

groove in the housing and slip it into

 

place. Snap the set plate back into place.

 

Be sure to close the set plate fully before

 

using the tool.

 

0 Do not use force when inserting the battery cartridge.

 

If the cartridge does not slide in easily, it is not being inserted correctly.

 

Charging

 

Plug the fast charger into your power

 

source. Insert the battery cartridge so that

 

the plus and minus terminals on the bat-

 

tery cartridge are on the same sides as their

 

respective markings on the fast charger.

 

Insert the cartridge fully into the port so

 

that it rests on the charger port floor.

 

The charging light will come on and charg-

 

ing will begin. If the charging light does

 

not come on, press the reset button. If the

 

charging light goes out within 10 seconds

 

even after pressing the reset button a

 

couple of times, the battery cartridge is dead. (CAUTION : Wait for more than 5 seconds

 

after the charging light goes out to press the reset button again.) Replace it with a new

 

one. When the charging light goes out after about one hour, you may remove the fully

 

charged battery cartridge.

 

After charging, unplug the charger from the power source.

 

CAUTION :

 

.Your new battery cartridge is not charged. You will need to charge it before use.

 

0 If you try to charge a cartridge from a just-operated tool, sometimes the charging light

 

will not come on. If this occurs, let the cartridge cool off for a while. Then re-insert it

.

and try to charge it once more.

0 When you charge a new battery cartridge or a battery cartridge which has not been used

 

for a long period, it may not accept a full charge. This is a normal condition and does

 

not indicate a problem. You can recharge the battery cartridge fully after discharging

 

it almost completely a couple of times.

 

0 If you wish to charge two battery cartridges, allow 15 minutes between chargings on the

 

fast charger.

 

6

Page 6
Image 6
Makita 6075DW instruction manual Installing or removing battery cartridge