Driving surface
Trigger
Operation
CAUTION:
•Make sure the safety system is in working order before operation.
To start driving, place the tip of the nail against the driving surface and pull the trigger. At the start of driving, apply gen- tle downward pressure on the nailer in the arrow direction to hold the nail firmly. When the impact of the contact arm stops, the driving operation is over. If the nail is not driven deep enough, place the ejection port of the nailer over the nail head. Press the nailer against the driving surface firmly and pull the trigger to do additional driving of the nail.
NOTE:
•The nailer will not operate unless you apply sufficient pressure to the contact arm. If this occurs, apply forward pressure to the nailer again while pulling the trigger to start operation.
1 Set the tip of the nail firmly against driving surface.
2 Pull trigger.
3Withdaw nailer from driving surface immediately after one or two impacts.
Nailing with one or two impacts
When you need to position a nail or drive a shallow nail:
1.Set the tip of the nail firmly against the driving surface.
2.Pull the trigger.
3.Withdaw the nailer from the driving surface immediately after one or two impacts.
NOTE:
•The impacts will continue as long as you keep the nailer pressed up against the driving surface, even if you release the trigger.
Metal plate Hole
Nailing in metal plate holes
CAUTION:
•Always make sure that the tip of the nail is inserted in the hole in the metal plate before you start nailing.
13
