Wiring diagram | P 11/ 13 |
|
Wiring around Controller
Fig. D-2
rib (A)
Route Lead wires from Switch unit (for rotation reverse) between rib (A) and rib (C).
rib (B)
Route Lead wires from Switch unit (for Trigger) between rib (B) and rib (C).
rib (C)
Put Power supply circuit
Switch
Route Lead wires (orange, white, blue) from Controller to Stator between the two pins.
pin
Put Connectors and the slack portion of Lead wires in the space between ribs (A)- (B)- (C) and pins- rib (D)- boss.
rib (D) Connector
boss
Controller
Put Connector and Lead
with Sponge on Housing (L) side.
Sponge
Put Lead wires from Controller to Power supply circuit on the
Power supply circuit
wires from Controller to Power supply circuit between the ribs on Controller.
Connector
groove on Controller.
groove
rib
RF unit
Terminal
Install Receptacles on Terminal as illustrated below.
Lead wire (black) | Receptacle |
|
Lead wire (red) 
Terminal
Route Lead wires that connects Power supply circuit with RF unit between three pins as illustrated below.
pin
pin
