P 12/ 13
Wiring diagram
[2] Wiring Around Stator
Fig. 30
Connector (to LED circuit) | Switch unit (for Clutch) |
Place Connectors and the sag of lead wires in the space between rib (E) and the inside wall of Housing.
inside wall of Housing | Connector |
Route the following lead wires from Controller between rib (E) and the inside wall of Housing;
*wires to LED circuit *wires to switch unit (for Clutch)
At this time, place the lead wires so that the tape is positioned beside Printed wiring board.
tape
Route the three lead wires (orange, white, blue) from Controller to Stator between the pin and Stator.
rib (E)
Printed wiring board 
pin
Stator
lead wire holder
First, put the following lead wires from Controller in place;
*wires to LED circuit
*wires to switch unit (for Clutch)
Then, with the lead wire holder, fix the lead wires (orange, white, blue) from Controller to Stator.
rib (F) | rib (G) |
Route the six lead wires (orange, black, white, yellow, blue, red) from Controller to Stator between rib (F) and rib (G).
