Makita EX2650LH specifications Engine and Shaft, Disassembling, Assembling

P 3/ 14

Repair

[4]DISASSEMBLY/ASSEMBLY

[4]-2. Engine and Shaft

DISASSEMBLING

Fig. 1

(1)	Disconnect lead wire and grounding wire by removing each connector
	after removal of Air cleaner cover. (Fig. 1)
(2)	Remove Control cable from Insulator as follows:
	• Loosen the nuts of Control cable so as to relax the holding to the hook of
	Insulator. (Fig. 2)
	• Disconnect Inner cable from Swivel of Carburetor.
(3)	Loosen two M5x18 Hex socket head bolts on Pipe holder and remove M5x12	Connector (4pcs.)
	Hex socket head bolt. (Fig. 3)

(4) Pull Shaft pipe B complete and Shaft B complete out of Engine. (Fig. 4)	Fig. 2
Note: Shaft B complete in the Shaft B pipe complete may get stuck	Swivel
at the spline engagement. If yes, use Waterpump pliers to pull out	Inner cable of
the shaft. (Fig. 5)
	Control cable
	Nut of Control cable
	(2 pcs.)

Hook of Insulator for Control cable

Fig. 3

M5x12 Hex socket head bolt

M5x18 Hex Pipe holder socket head bolt (2pcs.)

ASSEMBLING

Fig. 4

Engine

Shaft pipe B complete

Shaft B complete

Fig. 5

Waterpump pliers

Shaft B complete

Assemble by reversing the disassembly procedure.

•Set Control cable in place. (Figs. 2 and 6)

-Secure it on the hook of Insulator with two Nuts of Control cable.

-Fit Inner cable end into the groove of Swivel of Carburetor.

Note: Adjust the tension of the cable to allow the play 1mm up to 2mm.

Fig. 6

Inner cable end	Hook of Insulator
	for Control cable
Nuts to fix on
the hook of Insulator
Control cable