Makita EX2650LH specifications Brushcutter attachment, String trimmer attachment

P 4/ 14

Repair

[4]DISASSEMBLY/ASSEMBLY

[4]-3. Brushcutter attachment

DISASSEMBLING

(1)Loosen two M6x30 Hex. socket head bolts and remove Protector with Protector extension attached. (Fig. 7)

(2)While pulling the side walls of Protector cover toward outside, remove Protector cover from Shaft pipe A complete. (Fig. 8)

(3)Remove two M5x14 Hex socket head bolts and Protector clamp. (Fig. 9)

(4)Loosen M5x25 Hex socket head bolt and remove Gear case assembly from Shaft pipe A complete. (Fig. 9)

(5)Pull Shaft A from Gear case installation side and then remove Retaining ring S-7 from Shaft A. (Fig. 10)

(6)Push the projection of Leaf spring complete deeply and remove it from the hole of Shaft pipe A complete. Slip the projection along the inside of Shaft pipe A complete toward the shaft end. (Fig. 11) Leaf spring complete is removed from Shaft pipe A complete.

Fig. 7

	M6x30 Hex socket
Protector	head bolt (2pcs.)
Protector
extension

Note: Pushing the projection hard causes the deformation of Leaf spring complete. Be careful of the handling.

Fig. 8

Shaft pipe A complete

M5x14 Hex socket

head bolt

Side wall

of Protector

cover

Protector cover

ASSEMBLING

Fig. 9

Shaft pipe A complete

	M5x25 Hex
	socket head
	bolt
	Gear case
	assembly
M5x14 Hex	Protector
socket head
	clamp
bolt (2 pcs.)

Fig. 10

Shaft pipe A complete viewed from Gear case installation side

Retaining ring S-7

Shaft A

Fig. 11

Projection of Leaf spring complete

Spring portion of Leaf spring complete

Assemble by reversing the disassembly procedure.

[4]-4. String trimmer attachment

Fig. 12

DISASSEMBLING

(1)	Remove two M6x20 Hex. socket head bolts and Protector
	from Clamp complete. (Fig. 12)
(2)	Remove M5x10 Hex socket head bolt and Clamp complete
	from Head case. (Fig. 12)
(3)	Loosen M5x25 Hex socket head bolt and remove Head case
	from Bent pipe assembly. (Fig. 12)
(4)	Remove Bearing washer from Head case installation side of
	Bent pipe assembly. (Fig. 13)
	Remove Flexible shaft from Bent pipe assembly by pulling it

Bent pipe assembly

M5x25 Hex socket head bolt

M5x10 Hex socket

head bolt

M6x20 Hex socket

head bolt (2 pcs.) Clamp complete

Head case complete Protector

off from shaft joint side.

(5) Remove two M5x14 Screws. Cutter is removed from Safety

cover as drawn in Fig. 14.

Fig. 13

Bent pipe assembly viewed from Head case side

Flexible shaft Bearing washer

Fig. 14

M5x14 Screw (2 pcs.)

M5 Washer (2 pcs.)

M5 Spring washer (2 pcs.)

		M5 Nut
Safety cover	Cutter	(2 pcs.)