Repair

P 17 / 22

(6)Set change plate in the groove of clutch cam, and assemble the clutch cam with change plate to cam shaft as illustrated in Fig. 74.

(7)Assemble spur gear 10 to cam shaft as illustrated in Fig. 75.

(8)Assemble compression spring 7 to cam shaft, and secure the parts on cam shaft with retaining ring S-7 as illustrated in Fig. 76.

(9)Assemble compression spring 6 and flat washer 5 to the pin of inner housing. And secure them with stop ring E-5 as illustrated in Fig. 77.

(10)Apply 55g of MAKITA grease RA No.1 in gear housing.

Change plate

 

Clutch cam

Cam shaft

 

Fig. 74

Retaining

Change plate

 

ring S-7

 

Spur gear 10

Compression spring 7

 

Clutch cam

 

Fig. 76

Change plate

Spur gear 10

Clutch cam

Fig. 75

Compression spring 6

Stop ring E-5

Flat washer 5

Fig. 77

< 17 > Removing needle bearing complete

Strike the work table with gear housing. Then needle bearing complete can be separated from gear housing as illustrated in Fig. 78.

Needle bearing complete

Fig. 78

Page 17
Image 17
Makita HR2450FT, HR2450T specifications Repair