Note: Cross lines for locating and drilling holes are accurate. The illustration of subbase may vary slightly in size and design, but is accurate enough for cutting the rubber spacer if required.
NOTE: This router requires a 3/4" pocket or use of 8" X 8" black rubber spacer for router table installation. Pages 4,5,6.
Router table fence reference line
Router mounting holes
© 2000-2005 Router Technologies All Rights Reserved
Router Raizer Access Hole
3/4" reference circle for drilling the routers original subbase only. Table mounted, drill 1/2" hole in table top.
1/2" = .500
.500" reference circle for drilling table top or insert plate.
Refer to pages 28, 31, 32 before using template
Additional Templates Available on Website
Use this 6" scale to check accuracy when copied
Router Raizer Access Hole
Drill .500" hole through router table insert plate
install #30 dust cover insert into .500" hole and press flush with top of insert plate
NOTE: This hole must be drilled 1/2" or .500" for #30 dust cover insert to fit properly.
Makita 3612 B
