Makita BUR181, UR140D, UR180D, BUR141 dimensions Disassembly/Assembly

P 7/ 12

Repair

[3]DISASSEMBLY/ASSEMBLY

[3]-3. Pipe section (cont.)

ASSEMBLING

Assemble Pipe section as drawn in Figs. 7 and 8.

Fig. 7

1.Insert Pipe cap into Pipe 25 so that the square projection of Pipe cap fits in the left side of Pipe as drawn below.

Next, mount Rubber pipe 25 and Lock sleeve 25 onto Pipe 25.

2.Pass Power supply cord unit through Pipe 25.

Fit the square projection of Pipe cap into the inner groove of Handle (L).

Set Rubber sleeve 25 in place of Handle (L). Assemble Handle (R) to Handle (L).

Lock sleeve

Rubber sleeve 25

Pipe 25

Caution label

Two holes

on the pipe end close to caution label

Hole on the pipe end	Right
Left
Square projection	Pipe cap

Power supply	Caution label
cord unit	Note: Face the caution label
Rubber sleeve 25	upward as drawn in Fig. 8.
	Square projection of
	Pipe cap
	Inner groove
	as a guide rail for
	Pipe 25 moving
	Pipe 25

Handle (L)

Fig. 8

Caution label faced upward

3.Mount Lock off button B to Pipe holder (R) so that the notch aligns to the triangle mark as drawn below.

Note: Make sure that 2 pcs. of Rubber pin 6 are set in place.

Caution Label

Triangle mark on

Pipe holder (R)

Rubber pin 6 (2 pcs.)

Notch of Lock

off button B Lock off button B

4.While aligning the triangle mark of Lock sleeve to the symbol of “Unlock” on Handle (L), push Lock sleeve toward Handle complete until it clicks.

And turn Lock sleeve until its triangle mark aligns to the symbol of “Lock” on Handle (R).

	Triangle mark	Symbol of
Lock		“Lock”
	Symbol
sleeve
	of “Lock”	Handle (R)
Symbol of
“Unlock”
Handle (L)