Manitowoc Ice S1000M Removing the Front Panel, 4-11, Water Inlet Valve, Panel Removal, Section

Section 4 Maintenance

Water Inlet Valve

The water inlet valve normally does not require removal for cleaning. Refer to Section 5 for a list of causes for “No Water Entering Water Trough” or “Water Overflows Water Trough.

1.When the ice machine is off, the water inlet valve must completely stop water flow into the machine.

2.When the ice machine is on, the water inlet valve must allow the proper water flow through it. Set the toggle switch to ON. Watch for water flow into the ice machine. If the water flow is slow or only trickles into the ice machine, refer to Section 5.

Follow the procedure below to remove the water inlet valve.

!Warning

Disconnect the electric power to the ice machine and dispenser at the electric service switch box and turn off the water supply before proceeding.

1.Remove the 1/4” hex head screws.

2.Remove, clean, and install the filter screen.

FILTER

ACCESS

SCREWS

WATER

INLET

VALVE

SV1622

Removing the Front Panel

1.Disconnect power to ice machine.

2.Loosen thumbscrews. Do not remove, they are retained by o-rings to prevent loss.

Thumb

Screws

Panel Removal

Part Number 80-1561-3 4-11