STORAGE
Each hlt
MANTIS Tiller for an)' long period
1Do not store your Tiller with fuel still in it Even under ideal conditions,
stored fuel containing ethanol or MTBE can start to go stale in 30 days And, since stale fuel has a high gum content, it can clog the carburetor, this, in tmn, will resuict fuel flm_: So, when you're ready to store your Tiller, or will not be using it for more than 2 weeks, drain the fuel tank completely, (Picture 2)
2.Next, restart the engine to make sure no fuel is left in the carburetor.
Then run the engine until it stops lqais wilt pre_ent gum deposits, forming inside of the carburetor and possible engine damage.
3.Disconnect spark plug wire and remove the spark plug (Use the wrench that comes in our optional Hand}, item Kit, Item #8444 Or use a 19mm or 3/4"
of the cylinder walt
4..Replace the spark plug with a NGK- BPMSY A replacemem spark plug is included in the optional Handy Item Kit item # 8444.
5.Install the spark plug, but leave the spark plug wire disconnected
Your handles are now foIded and ready to store in a smaller area
t5 Do you have fuel Iefl over from last season? Dispose of it properly Buy fresh oil and gasoline next season
How to Prepare Your
MANTIS Tiller for
Restarting
Unfold the handles into an upright or
extended position Tighten the two handle knobs (#40)
In the Spring. when you take },our Tiller
out of storage, remove the spark plug.. Pull tire starter cord three or four times
to clean oil fl'om the combustion chamber
(Picture 4) Wipe oil from tile spark plug. Place the spark plug back into the cylinder
Again, Check the
Carburetor.
If },our Tiller won't restart in the Spring
due carburetor may need attention.. Follow tile steps on page 19 for adjusting the H and L screws (Picture 5)
AWARNINO.DANOERA
DO NOT STORE IN AN AREA WHEREFUEL FUMES MAY
i ACCUMULATEAND REACH A
::: :FLAME OR SPARK.
Picture l
(
Picture 2 | Pic;ure 3 |
6Clean the air fitter as described on Page t I.
7Clean dirt, grass, and other materials fi'om the entire machine..
8.Wipe the tines with off or spray them with
9.Oil the throttle cable and all visible
moving parts. (Do not remove the engine cover..)
10. Replace the fuel filter.
11.Check the grease level in the worm gear housing, as described on page I 1
t2 Order new parts to replace any that are badly worn or broken..Just call ,*'ourlocal authorized MANTIS dealer.
13Store your TilleL in an upright position, in a clean, dry place You can store with the bandies in an extended position or folded down. (Picture 1)
14To fold the handles, follow these
easy steps: Loosen tim handle knobs (#40), fold the handles forward (see
picture 1, inset) "i'ighten knob securel}:
Check the Spark Plug Too.
If your Tiller won't restart, or if it
lacks full power, the spark plug may be at fault Check to see if the plug is fouled with oily black deposits Clean or replace it if it is (Picture 6)
Also, check whether the center electrode is rounded at the end,
or' if the ground electrode is worn If either is the case, you should replace it with a
Caution: Do not over tighten
the plugo The correct torque is 18 to 22
17o avoid possible damage to the threads, do not try to remove the plug from a hot aluminum t3,Iinder head.
Picture 4
Picture5Picture6
...................:AwanmNaA:: : :II
:always | make sure the handle | II |
i:: i ::::knebs are secure before | II | |
::starting | your MANTIS Tiller. | I] |
|
| I |
13