Marantz AV7005 1, 2, 3, 4, 1, 2 3, 4, 1, 2, 3

31
Simple version Advanced version Information
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Basic version
Tuning in radio stations
nChecking the SIRIUS signal strength and radio
ID
1Press STATUS until
“SIGNAL” appears on the
display.
The display will switch as
shown below, depending on the
reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
2Adjust the position of the antenna until “SIGNAL:
EXCELLENT” is shown on the display.
3Press STATUS until the channel (example: “SR001”)
is displayed.
4Press TUNING + or TUNING –
and select channel 0 (SR000).
Channel No. and Sirius ID are alternately
shown on the display.
SR000 SiriusID
************
Sirius ID
• Write your own SIRIUS ID for storage use.
Sirius ID :
The strength of both the SIRIUS satellite and terrestrial signals can be
checked “Antenna Aiming” (vpage68).
nPresetting radio channels (Preset memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1Tune in the broadcast channel
you want to preset.
2Press MEMORY.
3Press SHIFT to select the block
(A to G) in which to preset the
channel (1 to 8 per block), then
press PRESET +, PRESET – or 1 –
8 to select the preset number.
4Press MEMORY again to complete
the setting.
• To preset other stations, repeat steps 1 to
4.
NOTE
Preset channels are erased by overwriting them.
nListening to preset channels
Press PRESET +, PRESET – to select
the desired preset channel, then press
ENTER.
• Preset channels can also be selected by
pressing SHIFT/TOP MENU (Block) and 1 –
8 (Channel).
You can also operate via the main unit. In this
case, perform the following operations.
Press o p to select the preset radio channel.
nSearching categories
1Press o p.
SR001 Hits 1
CAT : Pops
Channel category
2Use o p to select the category, to use ui to select
the desired channel.
nAccessing SIRIUS satellite radio channels
directly
1Press SEARCH/INFO.
2Press 0 – 9 to input the channel.
Example: Accessing channel “SR123”:
Press 1, 2 and 3.
• If no button is pressed within several
seconds, the channel automatically
switches to the one whose number has
been input.
3Press ENTER to set that channel.
Reception switches to the selected
channel.
• “UPDATING” is displayed while the encording code is being
updated.
• “SIRIUS UPDATING” is displayed when updating SIRIUS tuner
firmware.
• Refer to “Troubleshooting” – “SIRIUS Satellite Radio” (vpage113)
regarding other messages.
1.AV7005U_ENG.indd 31 2010/08/23 18:32:37