93
Basic versionSimple version Information
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Advanced version

Operating learn function

• If the AV device is not a Marantz device, or if the device does not
operate even when the preset code is registered, use the learning
function. Remote codes for different devices can be remembered
for use by the Marantz remote control included with this device.
• This remote control unit is capable of learning around 160 codes.

Remembering remote control codes from

other devices

1Place the Marantz remote control and remote control
from the other device approximately 5 cm apart,
with the remote control signal transmission sections
facing each other.
5 cm
2Press and hold down SET and
SOURCE SEL until the LEARN
indicator blinks.
3Press input source select buttons
to select the input source.
The input source is shown in the remote
control display.
4Select the button to be learned.
LEARN indicator lights up.
5Press and hold the button that you want to register
on the other remote control until “OK” is displayed
on the Marantz remote control display.
• If “NG” is shown on the remote control display, perform step 5
again. If “NG” is shown again on the remote control display, the
remote control may not be able to learn the code correctly. In this
case, use the specialized remote control for the device.
• If the remote control memory becomes full, “FULL” is shown
on the remote control display. If you want to learn the code, you
should erase other learned button.
6Repeat steps 4 and 5 to learn other buttons for the
same input source.
7Repeat steps 3 to 6 to learn other input sources.
8When programming of the remote control unit is
completed, press SET.
The LEARN display disappears, and the remote control unit
exits learn mode.
NOTE
• The learning function is unavailable for all SOURCE ON/OFF, MACRO
and HDMI in any mode.
• The learning function is unavailable for all buttons in TUNER mode,
AMP mode, NET/USB mode and M-XP mode.
• The learning procedure does not operate correctly if the batteries
have become worn.
• If no buttons are pressed for approximately 1 minutes while in the
LEARN mode, the remote control unit automatically exits from the
LEARN mode.
nSet top box for satellite (SAT) operation
Operation buttons Function
SOURCE ON/OFF Power on/standby
CHANNEL +, – Switch channels (up/down)
uio pCursor operation
ENTER Enter
0 – 9 Channel selection
CLR Clear the inputting
TV POWER TV power on/standby
(Default : Marantz)
TV INPUT Switch TV input
(Default : Marantz)
Operating components
1.AV7005U_ENG.indd 93 2010/08/23 18:33:20