Marantz CDR300 manual Controls, Connections front con- tinued, Input ANALOG/DIGITAL

Controls, Connections (front) con- tinued

4

5

6

7

8

INPUT

REC LEVEL

MIC/LINE ATT

SPEAKER

OPEN/CLOSE

MIC/LINE

ANALOG

DIGITAL

MANUAL

OFF

ON

OFF

ON

ALC

LIMITER

PHONE/SPEAKER PHONE SELECTOR

MIC

L

R

LEVEL

LINE OUT

LINE

INT

L/R

L + R

AUX

MIX OUT

MIC/LINE

PUSH

PUSH

PHONES

LINE OUT

Recordable

CD PLAY / RECORD

ReWritable

LEFT

MIC/LINE

RIGHT

SPEAKER

OFF ON

OPEN/CLOSE

7SPEAKER OFF/ON switch

Turns the built-in speaker OFF or ON.

8OPEN/CLOSE switch Push and release to OPEN the CDR drive.

9		10	11	12
	INPUT		4 INPUT ANALOG/DIGITAL
ANALOG		DIGITAL
			switch
			Select between analog or digital
			external input. Connect digital
			output of the source machine to

the DIGITAL IN jack on the rear of CDR300. Connect analog input to either the MIC/LINE input jacks on the front of the CDR300 and/or the AUX IN jacks on the rear of the CDR300.

REC LEVEL		5 REC LEVEL switch
MANUAL		Record level limiter for analog
ALC	LIMITER
		input during recording.
		ALC – Limits any input signal
		greater than -12 dB. Left and right
		MIC/LINE (or INT MIC) level

controls should be set to maximum.

MANUAL – Set level using left and right MIC/LINE (or INT MIC) level controls. When recording via AUX IN control the level using the output level control on the external device. Levels in excess of 0 dB will be recorded and will result in distorted recordings. LIMITER – Same as manual: Set level using left and right MIC/LINE (or INT MIC) level controls. Levels in excess of -12 dB are automatically limited.

Note: REC LEVEL adjustment is not available with this switch at ALC.

MIC/LINE ATT			6 MIC/LINE ATT switch
	OFF	ON
			Determines if the signal from the
			MIC/LINE inputs is attenuated.
			OFF – the signal(s) is not attenu-
			ated.
			ON – The signal is attenuated
approximately 20 dB to prevent distortion.

CDR drive open

To CLOSE the CDR drive, push and release the OPEN/CLOSE switch.

PHONES 9 PHONES jack

Plug stereo headphones in here.

Adjust headphone volume with the

PHONES/SPEAKER LEVEL control.

LINE OUT 10 LINE OUT level control

Turn to adjust the level of the output to the LINE OUT jacks.

11CDR drive (disc tray)

The CDR drive is used for recording and can record CD-R and CD-RW discs. The CDR drive can also playback CD, CD-R and CD-RW disks

12Remote control sensor

Sensor for the supplied wireless remote control.

Note: Set the REMOTE EXT. INT. switch on the back to INT. to enable the wireless remote control.

- 14 -