20
CONNECTING EXTERNAL VIDEO SOURCES
CONNECTING AN S-VIDEO VCR OR LASERDISC PLAYER1. Connect the cable from the S-VIDEO OUT of the VCR or the laserdisc player to the VIDEO input (S-VIDEO) jack, as shown onthe TV set below.2. Connect the cable from the AUDIO OUT R of the VCR or the laserdisc player to the VIDEO input (AUDIO/R) jack.3. Connect the cable from the AUDIO OUT L of the VCR or the laserdisc player to the VIDEO input (AUDIO/L) jack.4. Press the VID1~VID3 button to view the program from the VCR or laserdisc player. The VIDEO icon disappears automaticallyafter approximately eight seconds.5. Press the ANT button to return to the previous channel.NOTES: 1. Completely insert the connection cord plugs when connecting to rear panel jacks. The picture and sound that is played back will be abnormal if the connection is loose.
2. A single VCR can be used for VCR #1 and VCR #2, but note that a VCR cannot record its own video or line output.(INPUT: 1 in example on page 13) Refer to your VCR operating guide for more information on line input-output connections.S-VIDEO
R L V
ANT ATOCONVERTERANT B12345
678910
1112131415
AUDIO
L
R
(MONO)
VIDEO VIDEO
AUDIO
(MONO)
L
R
AUDIO
(MONO)
L
R
VIDEO
S-VIDEO S-VIDEO
Y
B
R
P
B
R
P
P
S-VIDEO
L
R
STOP
CONNECT ONLY 8 OHM SPEAKERS
DO NOT SHORT CIRCUIT
THESE TERMINALS
(Such damage is NOT COVERED
by your television warranty)
REAR SPEAKER8Ω ONLY
-
L+
-
+
RPC 1
AUDIO
INPUT
MONITOR
OUT
VIDEO 2VIDEO 1AUDIO OUTL
R
SUBWOOFEROPTICALCOAXIALDIGITAL INRear Panel of Television
VCR or Laserdisc Player
OUTPUT
See tips on
Page 12
Back of VCR or
Laserdisc Player
P
Y