9
FRONT PANEL JACKS AND CONNECTIONS

NOTE: Optional adapter for *Apple®Macintosh®computers. If the optional AESP model G301/U Macintosh to VGA®adapter

connector is configured and connected between Macintosh video out and the Rear Projection Television video in, the

Macintosh is “forced” to boot in 640 x 480/60 Hz or 800 x 600/60 Hz mode (set mode) because the operational adapter

correctly manipulates the Macintosh sense pins.

For the optional adapter to work, its DIP switch settings should be # 2, 3, 6, 7 = ON and # 1, 4, 5, 8, 9, 10 = OFF.

See below: Example - See Switch Instructions for details.

Mode 5 = 2367 (SVGA 800 x 600/60 Hz configuration)

(VGA 640 x480/60 Hz configuration)

Composite Separate Sync

ON DIP12345678910
ON
1458910
2367
OFF

SW1 SW2 SW3 SW4 SW5 SW6 SW7 SW8 SW9 SW10

ON ON ON ON

OFF OFF OFF OFF OFF OFF

A/V Cable and
S-INPUT Cable
(Optional)
Back of VCR
D-SUB 15 Pin
RGB Cable
(Optional)
PC
AUDIO OUTBack of PC
Audio Cable
(Optional)
S-VHS Video Camera Output
VIDEO 3
VOL-
AUDIO IN
VIDEO 3/PC2
L/(MONO) R
VIDEO
S-VIDEO
PC2
12345
678910
1112131415
INPUT VOL+CH- CH+
TV/PCEXIT
MENU
SELECT
VIDEO 3
VOL-
AUDIO IN
VIDEO 3/PC2
L/(MONO) R
VIDEO
S-VIDEO
PC2
12345
678910
1112131415
INPUT VOL+CH- CH+
TV/PCEXIT
MENU
SELECT
VIDEO 3
VOL-
AUDIO IN
VIDEO 3/PC2
L/(MONO) R
VIDEO
S-VIDEO
PC2
12345
678910
1112131415
INPUT VOL+CH- CH+
TV/PCEXIT
MENU
SELECT
V L RS-VIDEOOUTPUT

NOTE: Completely insert connection cord plugs when connecting to front panel jacks. If you do not, the played back picture may

be abnormal. If you have an S-VHS VCR, use the S-INPUT cable in place of the standard video cable. If you have a

mono VCR, insert the audio cable into the left audio jack of your TV. VIDEO 3 audio can be used for PC 2 audio when

a PC 2 is connected.

The front panel jacks are provided as a convenience to allow you to easily connect a VCR, PC or camcorder as shown in the

following examples: