Marantz PM-11S1 manual HOW to SET ID, When finished setting the ID number, turn power to the PM

HOW TO USE AND SET FEATURES

HOW TO ADJUST DISPLAY CONTRAST

An LCD is used as the PM-11S1’s display. You can set the contrast in the +8 - -8 range. When the PM-11S1 is shipped from the factory, the contrast level is set to 0. The contrast adjustment mode is accessed by activating power from the POWER ON/OFF button while pressing and holding the DISPLAY button. Contrast is then set by turning the INPUT SELECTOR knob to the desired setting.

1.While pressing and holding the DISPLAY button, press the POWER ON/OFF button.

2.Turn the INPUT SELECTOR knob to the desired contrast setting.

3.When finished setting the display contrast, turn power to the PM-11S1 OFF. The setting is stored in memory and becomes active the next time power to the PM-11S1 I activated.

HOW TO SET ID

If using the PM-11S1 by itself as a stereo amplifier, set the ID to “0”. When the PM-11S1 is shipped from the factory, the ID is set to “0”.

When the ID is set to a number other than “0”, the PM- 11S1 cannot be used for standalone operation.

The ID number of the PM-11S1 appears on the display for about 3 seconds after power is activated.

When multiple PM-11S1s are connected, a unique ID number must be set for each one in order to distinguish between them. The PM-11S1 that centrally controls the other PM-11S1s takes ID 1. The PM-11S1 with ID 1 is called the “master”. The other PM-11S1s that synchronize with the master are called “slaves” and take IDs “2” - “4”. ID numbers must not be the same for any two units.

Set ID numbers as follows.

1.While pressing and holding the DISPLAY button, press the POWER ON/OFF button.

ENGLISH

INPUT SELECTOR knob	DISPLAY button
	2. Press the DISPLAY button once.
	INTEGRARED AMPLIFIER PM-11S1
DISPLAY
TONE	3. Turn the INPUT SELECTOR knob to the desired ID number.
	OPERATE
SPEAKER
A
INPUT
SELECTOR

POWER ON/OFF

SPEAKER	PHONES
B

	When finished setting the ID number, turn power to the PM-
	11S1 OFF. The setting is stored in memory and becomes active
	the next time power to the PM-11S1 activated.
POWER ON/OFF button

21