Marantz SR-18EX manual Rear Panel Connections, English

ENGLISH

REAR PANEL CONNECTIONS

All connections to the rear panel should be made with the entire system powered off.

To avoid errors, it is advisable to connect one cable at a time between the various components.

		11
20	10	16	17	18	14	1	2	13	21

COAX

OUT

OPT

OUT

DIG .1

IN

DIG .2

IN

DIG .3

IN

DIG .4

IN

FRONT		SURROUND				(FRONT)
L	R	L	R		L		R
FRONT		SURROUND				(FRONT)
L	R	L	R			L	R	SUB
FRONT		SURROUND		CENTER	SURROUND BACK WOOFER
								SUB
FRONT		SURROUND		CENTER	SURROUND BACK WOOFER
		S - VIDEO
		S - VIDEO
TV	LD	DVD	VCR1	VCR1	DSS / VCR2 DSS / VCR2			MONI.
S2TVIN	S2LDIN	S2DVDIN	S2VCR1IN	OUTVCR1	DSSS2 /INVCR2 DSSOUT/ VCR2 S2MONI.OUT
S2 IN	S2 IN	S2 IN	S2 IN	OUT	S2 IN		OUT	S2 OUT
		VIDEO						MONI.
		VIDEO						MONI.

				R	FRONT	L
					(SURR. BACK)
MAIN	FM (75Ω ) GND	AM
MAIN			ANTENNA
PRE			ANTENNA
				R	SURROUND	L		CENTER
OUTPRE
OUT	COMPONENT VIDEO
Y	COMPONENTCr	VIDEO	Cr
	Y
	Cr		Cr
VCR1			DVD
IN			INDVD
MONITOR			DSS	SPEAKER	SYSTEMS		8 OHMS
			/ VCR2DSS
OUT				SPEAKER	SYSTEMS		8 OHMS
			/ INVCR2
						AC OUTLETS		AC INLET

	DIRECT IN			120VAC OUTLETS60HZ	AC INLET
				SWITCHED120V 120W60HZ1A
	SUB
				SWITCHED 120W 1A
MULTI	CENTER WOOFER	SURROUND
ROOMMULTI
ROOM
				UNSWITCHED 120W 1A
		L	R	UNSWITCHED 120W 1A

DIG .5 IN

DIG .6

IN

L										IN
										OUT
R										OUT
TV	LD	DVD	IN – VCR1 – OUT	IN – DSS/VCR2 – OUT	AUDIO	CD	IN – TAPE – OUT	IN – CD-R / MD – OUT	REMOTE	MULTI
TV		DVD	IN VCR1 OUT	IN DSS/VCR2 OUT	AUDIO	CD	IN APE OUT	IN CD-R / MD OUT	REMOTE	MUL
		AUDIO			MULTI		AUDIO		REMOTE CONTROL
					ROOM
		AUDIO			MULTI		AUDIO		REMOTE CONTROL
					ROOM

19	9	5	6	12	3
		8		15

1 FM antenna terminal (75 ohms)

Connect an external FM antenna with a coaxial cable, or a cable network FM source.

2 AM antenna and ground terminals

Connect the supplied AM loop antenna. Use the terminals marked “AM” and “GND”. The supplied AM loop antenna will provide good AM reception in most areas. Position the loop antenna until you hear the best

3 Three analog audio inputs

CD, TAPE, and CD-R/MD :

Connect the audio outputs of your source components to the input jacks on the receiver.

4Two analog audio outputs for audio source equipment

TAPE and CD-R/MD :

Connect each output to the audio inputs (REC in) of your recording equipment.

5Five analog audio inputs for video source equipment

TV,LD,DVD, VCR1, and DSS/VCR2 :

Connect each input to the audio outputs of your video source equipment.

6Two analog audio outputs for video source equipment

VCR1, and DSS/VCR2 :

Connect each output to the audio inputs (REC in) of your video recording equipment.

4 22 23 7 24 25

7 6-Channel Inputs

If an external digital audio decoder is used, connect the outputs of that decoder to these jacks. Note that front L&R channels are common used in analog audio inputs, use the assigned input in OSD setup menu system.

(See page 17 “System setup 1/2”.)

8 Five video inputs

TV,LD,DVD, VCR1, and DSS/VCR2 :

Connect each input to the video outputs of your video source equipment.

9 Two video outputs

VCR1, and DSS/VCR2 :

Connect each output to the video input (REC in) of your video recording equipment.

10 Five S-video inputs

TV,LD,DVD, VCR1,and DSS/VCR2 :

Connect each input to the S-video outputs of your video source equipment.

11 Two S-video outputs

VCR1, and DSS/VCR2 :

Connect each output terminals to S-video input (REC in) of your video recording equipment.

12 Monitor. (VIDEO/S-VIDEO) output jacks

Connect this jack to the composite or S-Video input of a TV monitor or video projector to view the on-screen menus and the output of any standard video source selected by the receiver’s video switcher.

10