Marantz SR5009 owner manual 222

Contents	Connections		Playback	Settings	Tips	Appendix
Symptom				Cause / Solution			Page
Dolby PLg mode or DTS	0	It cannot be selected when “Speaker Config.” - “Center” or “Surround” is set for “None”.					189
Neo:6 mode cannot be
	0	Dolby PLg or DTS Neo:6 cannot be selected when using headphones.					－
selected.
Audyssey MultEQ® XT,	0	These cannot be selected when you have not performed Audyssey® Setup.					178
Audyssey Dynamic EQ®
	0	Switch to a sound mode other than “Direct” or “Pure Direct”.					120
and Audyssey Dynamic
	0	These cannot be selected when using the headphones.					－
Volume® cannot be
selected.
“M-DAX” cannot be	0	Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of					156
selected.		multichannel signals such as Dolby Digital or DTS surround, “M-DAX” cannot be used.
	0	Switch to a sound mode other than “Direct” or “Pure Direct”.					120
No sound is output when	0	Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL)					－
using ZONE2.		cannot be played back. Use analog connections.
	0	When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the					－
		Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m.

Front panel Display Rear panel 222 Remote Index