REMOTE CONTROL UNIT RC7200SR
This chapter describes the functions which need to control the SR7200. See page 19 and following pages to refer other function of the RC7200SR.
cPOWER ON and OFF
These two buttons are use for turning on or off SR7200.
bLCD
Used to display information about currently selected modes and functions.
nJog Dial control
Rotate this dial to select commands displayed on the LCD for each function. (See page 26)
Refer to follow.
Function | Jog Dial command | Note | |
AMP | 1 A/D | switches analog/digital input | |
| 2 | ATT | switches attenuator for analog input |
| 3 | NIGHT | selects NIGHT mode for Dolby Digital |
| 4 | turns | |
| 5 | turns | |
| 6 | activates | |
| 7 TRB+ | increases treble | |
| 8 TRB- | decreases treble | |
| 9 | BAS+ | increases bass |
| 0 | BAS- | decreases bass |
TUNER | 1 FM | FM band | |
| 2 AM | AM band | |
| 3 LW | Long Wave band | |
| 4 | mono/stereo mode selector | |
⊗ | 5 | SCAN | programmed preset channel scan |
6 STM | selects station mode | ||
⊗ | 7 | inputs a frequency directly | |
8 PTY | selects PTY function | ||
⊗ | 9 | DISP | selects display function |
0 DWR | selects DSR wave range |
The marked “⊗” commands are not used for SR7200.
mENT buttons
Press this button to enter the selected command by the Jog Dial.
,FUNCTION buttons
Press one of these buttons twice within 2 seconds to select the input function of SR7200.
Press one of these buttons once to change the state of remote commander.
.VOLUME up / down buttons
These buttons are used to raise and lower the SR7200’s volume level.
⁄0CURSOR buttons
The cursor buttons can be used to navigate within
⁄2Channel up / down buttons
Used to controls the up/down function of tuner, or allows one to cycle through the tuner presets.
⁄3MUTE button
This button can be used to mute the sound temporarily.
⁄5CLEAR button
This button is used to cancel certain memory or programming operations.
⁄6MEMO button
This button is used to enter the tuner preset memory numbers and station names.
⁄7TEN KEYPAD
They are useful for tuning a
OPERATION OF REMOTE CONTROL UNIT | ENGLISH | |
1. Remote control | ||
|
The distance between the transmitter of the remote control unit and the IR SENSOR of the SR7200 should be less than about 5 meters. If the transmitter is pointed to a direction other than the IR SENSOR or if there is an obstacle between them, remote control may not be possible.
SR7200
60°
Remote control unit (RC7200SR)
2. Loading batteries
The life of the batteries used with the remote control unit is about 4 months with normal use. Also be sure to replace batteries earlier when you notice that they are getting weak.
(1) Remove the back cover.
(2)Insert the new batteries (AA type) with correct (+) and
(3) Close until it clicks.
7