Marantz VP8600 manual Rear and Terminals View

Rear and Terminals View

ENGLISH

z x	c
⁄2	v
⁄1
⁄0
. , m	n b

zS-VIDEO IN

Connect an S-video enabled device.

xVIDEO IN

Connect a composite video enabled device.

cCOMPONENT VIDEO IN 1

Connect a component video enabled device.

vCOMPONENT VIDEO IN 2

Connect a component video enabled device.

bRGB IN

Connect to a computer.

nDVI-D IN

Connect a DVI (digital) cable from a computer or video source.

mRS-232C

This is a service port for firmware upgrades.

,TRIGGER 1

Connect to the screen.

When the unit is turned on, 12V is output. When the unit is turned off, no voltage is output. This allows such as a powered up/down screen,whenever the projector is turned on or off.

Note:

To connect with external devices, use an ordinal 3.5mm mini-plug (mono) cable.

.TRIGGER 2

Connect to the screen to control screen aspect ratio with powered up/down dual aspect ratio screen. If Normal (4:3) aspect ratio is selected by projector, 12V is output.

Notes:

•Do not use TRIGGER 1 and TRIGGER 2, as the power source.

•To connect with external devices, use an ordinal 3.5mm mini-plug (mono) cable.

⁄0IR receiver

Rear receiver for IR signal from remote control.

⁄1Main power switch

Turns the main power to the unit on or off.

⁄2AC IN socket

Connect to an electrical outlet.

Note:

•If your video equipment has both S- video and RCA jacks (composite video) connect to the S-video connector.

S-video provides a better quality signal.

4