CONNECTIONS
CONNECTING AUDIO COMPONENTS
There is one Audio EXT INPUT jack on the rear panel. You can use this jack to input analog audio signal from CD, TAPE DECK, or other analog source component.
CONNECTING AC POWER CABLE
Connect the AC power cable of the ZC4001 to a wall electrical outlet. Also connect the AC power cable of the ZR6001 to a wall electrical outlet.
ROOM A |
ZR6001 |
Home power line
Notes: | ENGLISH | |
• The ZC4001 and ZR6001 send audio data over power lines. Therefore, if the condition of the power line | ||
|
degenerates seriously because of the effects of noise from other devices or for other reasons, audio data may not be received or may skip.
• If the distance of the power line between the ZC4001 and ZR6001 is very long, audio data may not be received or may skip.
• At the time of purchase, all ZC4001 and ZR6001 are set to the same Group ID. If used with this same Group ID, you risk having your music listened into by others. Therefore, set the Group ID as explained herein.
• If the following trouble is experienced, block PLC signals from other sources using a commercially available power filter, etc.
When a ZC4001 and ZR6001 are connected over PLC, another ZR6001 cannot be added to the same power line and connected over PLC. In this case, PLC signals are not sent.
ZC4001 |
|
ZC4001 |
|
ZR6001 | ZR6001 |
ROOM B |
ZC4001 |
ROOM C |
ZC4001 |
If a ZR6001 and ZC4001 are connected over PLC in a nearby apartment unit for example, and there is only a short distance between your apartment and your neighbor’s, the PLC signals from your neighbor’s apartment can travel over power lines to your place, mix with your system, and prevent audio output.
ZC4001 | ZC4001 |
Up to four ZC4001 units may be connected to the same system at one time.
ZR6001 | ZR6001 |
5
