Marathon F200060 manual Bits 0 4 Oxygen Exponent, Bits 5 6 Display Decimal Place

				BLOCK 0
HEX	DEC	PARAMETER	DESCRIPTION		READ/WRITE
			BITS 0 - 4 OXYGEN EXPONENT
			RANGE = 0 to 31, where 2 = % and 6 = ppm
			DEFAULT = 2
			BITS 5 - 6 DISPLAY DECIMAL PLACE
			where:
			0 = no decimal point in display
			1 = Display XXX.X
			2 = Display XX.XX
			3 = Display X.XXX
			DEFAULT = 0
			BITS 8 – 12 REDOX METAL NUMBER
			RANGE = 0 – 14
			DEFAULT = 0
			BITS 13 – 15 SPARE
0A	10	FAULT	FAULT BIT MAP		READ ONLY
			BIT 0 = Temperature Input Open
			BIT 1 = MV Input Open
			BIT 2 = Range of input is low
			BIT 3 = Range of input is high
			BIT 4 = Timer End
			BIT 5 = Probe Care Fault
			BITS 6 – 7 = SPARE
			BIT 8 = CPU Fault
			BIT 9 = Min Idle counter = 0
			BIT 10 = Keyboard failure, stuck key or a key
			was pressed during power up.
			BIT 11 = Flash Erase Failed
			BIT 12 = Flash Checksum Failed
			BIT 13 = EEPROM Checksum Failed
			BIT 14 = Flash/EEPROM Size Fault
			BIT 15 = ADC Fault
0B	11	ASRC	ANALOG OUT SOURCES		READ/WRITE
			LOW BYTE, ANALOG OUTPUT 1
			BITS 0 – 3
			0000	= N/A
			0001	= Temperature
			0010	= Linear Input A
			0011	= Carbon value
			0100	= Dewpoint value
			0101	= Oxygen value
			0110	= Redox value
			0111	= Output Power
			1000	= Control Output 1
			1001	= Control Output 2
			1010	= Linear Input B
			1011	= Programmable*
			*For Programmable, write required output
			value into DACV1, where DACV1 = 0 is
			minimum output and
			DACV1 = 4096 is maximum output.
			BITS 4 – 7 SPARE

Page 14 of 23

11/14/2006 Rev. 14