Marathon F200060 manual Page 16 of

HEX

DEC

BLOCK 0

PARAMETER DESCRIPTION

READ/WRITE

			source value is based on the selection in
			ASRC upper byte where
14	20	SPARE	SPARE	READ/WRITE
15	21	SPARE	SPARE	READ/WRITE
16	22	SPARE	SPARE	READ/WRITE
17	23	TEMPFIL	Temperature Input Filter in seconds	READ/WRITE
			Range = 0 to 3276. The higher the number
			the faster the reading update.
			DEFAULT = 1000
			BLOCK 1
HEX	DEC	PARAMETER	DESCRIPTION	READ/WRITE
18	24	MVFIL	Millivolt Input Filter in seconds	READ/WRITE
			Range = 0 to 3276. The higher the number
			the faster the reading update.
			DEFAULT = 1000
19	25	AZERO	LINEAR OFFSET, Y INTERCEPT LINEAR	READ/WRITE
			SCALING FOR INPUT A
1A	26	ANUM	LINEAR SPAN VALUE FOR INPUT A	READ/WRITE
1B	27	BZERO	LINEAR OFFSET, Y INTERCEPT LINEAR	READ/WRITE
			SCALING FOR INPUT B
1C	14	BNUM	LINEAR SPAN VALUE FOR INPUT B	READ/WRITE
1D	15	PROC	This value is the calculated process value	READ ONLY
			shown as an integer. The decimal point and
			exponent values are required to determine the
			actual scaled value.
			Range = -999 to 9999.
			For example: If the process = oxygen, display
			decimal point = 2, and exponent = 6, and
			PROC = 1234, then the actual value and
			displayed as 12.34 ppm.
1E	16	COLDJCT	COLD JUNCTION	READ ONLY
			Where 1 COUNT = 1°F (°C), RANGE = -99 TO
			255°F (°C). Note this parameter is an
			unsigned integer.
1F	17	TEMP	MEASURED TEMPERATURE	READ ONLY
			Where temperature is presented in degrees C
			or F, based on the C/F setting. Note this
			parameter is an unsigned integer of
			temperature -2721 = 62815
			Range = max / min range of selected
			thermocouple.
20	18	MV	MEASURED MILLIVOLT	READ ONLY
			Where this value is scaled in 0.1 mV
			increments, i.e. 10001 = 1000.1.
			Range = 0 to 2000 mV.
21	19	DACV1	ANALOG OUTPUT 1	READ/WRITE
			0 to 4095 is 4 to 20 mA In dual mode 4mA = -
			100, 12mA = 0, 20mA = +100

Page 16 of 23

11/14/2006 Rev. 14