Mark Levinson
Banana plugs can also be used to connect the speaker cables to the loudspeaker binding posts. Banana plugs are not available on the 230 VAC model.
Caution! DO NOT OVERTIGHTEN the binding posts. The innovative design of these binding posts provides more leverage; hence,
DO NOT FORCE the binding post “wings” over a bent or over- sized connector. Doing so may damage the binding post.
Trigger Input and
Output
10
Power Save Mode
Switch
The rear panel of the Nº532 has two trigger connectors – one input and one output. The trigger input can receive a
The triggers enable the power amplifier to be automatically powered on or put into Standby or Power Save mode, by the state of other devices in the system. The Nº532 can also affect other power amplifiers in the same manner.
Receiving a trigger signal causes the Nº532 to change its power state. If the Nº532 is powered on, then 0V on the trigger signal puts the amplifier into Standby or Power Save mode. Conversely, an amplifier in Standby mode is powered on when
The Power Save Mode switch on the rear panel enables the
•When set to ON, the amplifier enters the Power Save mode when the amplifier power is turned on. The Standby button switches the amplifier between the Power Save and On modes.
•When set to OFF, the amplifier enters Standby mode when the amplifier power is turned on. The Standby button switches the amplifier between the Standby and On modes.
When the Power Save mode is active, AC power is only connected to the