Nº532 Power Amplifier
Discovering Slaves
Status Reporting
Fault Reporting
The figure below illustrates a typical ML Net setup:
Before the master device can control any slave device, the slave devices must be “discovered” and assigned to the master device.
Refer to the Owner’s Manual of the designated master device for 21 further information about discovering and assigning slave devices.
The Nº532 slave(s) can report the following status information to the master device:
•Temperature – the current operating temperature of the amplifier(s).
•Session Time – the amount of time that the amplifier(s) has been powered on.
•Total On Time – the total amount of hours that the Nº532 amplifier(s) has been powered on since its manufacture.
If a slave device is inactive, unassigned, or assigned to a different master, then status information is not available.
The Nº532 slave(s) also reports fault information to the master device. If a slave device is inactive, unassigned, or assigned to a different master, then error reporting is not available. For more information about possible fault conditions, refer to the “Troubleshooting” section of the manual.
