Mark Levinson N26 manual Rear panel, Precaution

2 4 4 10

BALANCED OUTPUT

RL

MAIN OUT

RL

TUNER

TAPE 2 OUT

RL

TAPE 2 IN

TAPE 1 OUT

RL

TAPE 1 IN

POWER	DUAL MONAURAL
SUPPLY
	PREAMPLIFIER
INPUT
	Nº 26

CD

R L

DESIGNED AND MANUFACTURED

IN U.S.A. BY

MADRIGAL

AUDIO LABORATORIES INC.

S/N:

AUX 1

R L

OPTIONAL BALANCED INPUT

R AUX 2 L

PUSHPUSH

PHONO/AUX 2

R L

1 3 5 5 6 7 8 9 11

PRECAUTION

Rear panel

Disconnect all associated equipment from the AC mains BEFORE making any signal connections and applying power to the Nº26/PLS- 226.

1BALANCED OUTPUT

If your power amplifier is equipped with balanced input connectors, it's best to connect it to the Nº26 via these connectors, particularly if long cable lengths are required.

Connect the right-channel and left-channel BALANCED OUTPUT of the Nº26 to the appropriate balanced inputs of the power amplifier.

The pin assignments of these XLR-type male outputs are:

PUSH		Pin 1: Signal ground
2	1	Pin 2: Signal + (non-inverting)
		Pin 3: Signal – (inverting)
3

Connector ground lug: chassis ground

Refer to your power amplifier's operating manual to verify that the pin assignments of its input connector correspond to the Nº26. If not, wire the cable so that the appropriate output pin connects to the equivalent input pin.

2MAIN OUT

Connect these outputs to the right-channel and left-channel inputs of your power amplifier or electronic crossover.

These outputs are affected by the OUTPUT LEVEL control on the front panel of the Nº26.

3TUNER

Accepts right-channel and left-channel signal leads from a tuner or other line-level source equipment.

3