Mark Levinson N32 owner manual Loosen each gold thumb screw a few turns

5.Loosen each gold thumb screw a few turns.

You do not have to remove the thumbscrews—just loosen them enough to slide the leads of your resistor in the gap.

6.Place the leads of resistor between thumb screws and ter- minal posts.

7.Tighten thumb screws firmly.

The result should look something like the photo below (although your resistor may well look different).

27

8.Trim lead if necessary to avoid contact with other compo- nents.

Be careful to keep the trimmed lead wires from falling into the phono module.