Important!
12Warning!
Warning:
Installing the Nº32 Reference Phono Preamplifier Modules
Installation of the Nº32 Reference Phono Preampllifier Modules should be done by a qualified and authorized Mark Levinson dealer. The following description is provided for your reference (and that of the dealer). Failure to observe proper ESD (electrostatic discharge) procedures may result in damage the preamplifier.
The optional Nº32 phono preamplifier modules may be installed inside of the Nº32 preamplifier for seamless integration of a phonograph into an audio system built around the Nº32. These modules are available equipped either with XLR or the more common RCA connectors. The following instructions apply to either version.
Do not attempt to use your Nº32 Reference Phono modules unless your Nº32 Controller is using version 1.04 (or greater) of its operating software.
Prior to installation, check your software by pressing setup and turn- ing the select knob one click to the left. Read the number on the right side of the resulting display. It should be at least 1.04.
If you need new software, please contact your authorized Mark Levinson dealer or distributor. Install this software before continuing with the phono module installation.
Before continuing, turn off the Nº32 Controller, and remove the DC power cables from the Nº32 Preamplifier. Once the Preamplifier top cover has been removed, please use the supplied wrist strap between you and the chassis of the Nº32 Preamplifier (not the Controller) to prevent ESD damage.
