Warning:
Installing a Custom Load
A pair of gold plated screw terminals is available inside each of the Nº32 phono preamplifier modules. It may be used to install a “custom” resistor for phono cartridge loading, in the case where a value is desired that not available from the existing set (3.3Ω, 5Ω, 7.7Ω, 10Ω, 33Ω,
50Ω, 77Ω, 100Ω, 330Ω or 47kΩ). These user input load terminals are only accessible with the phono modules removed from the Nº32, since they are internal to those modules.
Note: the
(47000Ω times your resistor value)⎟(47000Ω plus your resistor value).
This distinction is usually not significant when your resistor value is below a few thousand ohms.
Touch the metal enclosure of the module before |
|
touching any component within the module to prevent |
|
ESD (electrostatic discharge) damage. | 25 |
If your phono modules are already installed in your Nº32, you will need to remove them before you can access the
To install