
For example, if you are using only two or three inputs on your Nº383, you may disable the unused ones so that the select knob selects only among connectors you are actually using. For more information on customizing your integrated amplifier in this and other ways, please see “Customizing Your Nº383.”
3Alphanumeric Display
This
normal operation | the selected input name and volume setting |
balance | direction and magnitude of balance offset |
setup | setup menus and settings |
In addition, this display will indicate any known fault conditions. For example, it will also inform you if the amplifier section has shut down due to the presence of DC offset at the input or the output. For more detailed information on the preamplifier’s use of this display, please refer to the following section on the use of the balance button, as well as the section on “Customizing Your Nº383.”
16
4Polarity Indicator
The polarity (sometimes inaccurately called “absolute phase”) of the output of the Nº383 may be inverted via the Nº383 remote control, in which case the red LED under the word polarity (within the display window) will light as confirmation. A second press of the polarity button on the remote control will restore the polarity of the output to its original,
5Volume Knob
This control is normally used to adjust the listening volume, and does not effect the level of the signal being sent to the record out- put. When in balance mode, this knob is used to vary the relative output of the Left and Right channels. It is also used during setup for various adjustments; see “Customization of your Nº383.”