reset defaults If necessary, it is possible to reset all of the factory default settings for the Nº383 Integrated Amplifier so as to start again with a “clean slate.”
Important Note: | Resetting factory default settings causes any |
| customization of the unit to be lost, including custom |
| names, gain settings, offsets, etc. |
|
|
To reset all settings of the Nº383 to the original factory settings,
1.Turn off power
You may either unplug it from the ac mains or use the front panel power button; standby will not do. Wait for a few seconds for the power supply to drain.,
2.Restore power while holding the setup button.
This process takes a few seconds, as a guard against accidental res- toration of factory defaults.
39
3.Continue holding the setup button for about ten seconds after the display reads “CLEAR SETUP?”
If you take your fingers off the buttons within these first ten sec- onds or so, the operation will be cancelled, leaving your current settings unchanged. If you persist in holding the setup button, the display will show “FACTORY” “SETUP” “RESTORED” in sequence.