Marmitek 20041, 100304 owner manual Universal remote 5in1, Clearing the memory master reset

6.3Method C: scanning the frequency band with the use of the CableLink 75 channel numbers

NOTE: The CableLink 75 system uses it’s own channel numbering. The numbers used by the CableLink system will therefore NOT correspond directly with the channel numbers on the channel overview of your Cable TV provider or the channel numbering you used with your TV or VCR.

1.Take the channel overview chart of your Cable TV provider or the terrestrial channel overview for your region with an overview of both TV channels and frequencies [MHz].

2.In the back of this owner’s manual you will find a table that contains the following columns:

•Frequency: Frequencies belonging to the TV channel

•CableLink 75 channel nr.: CableLink 75 own channel number which will be linked to the TV channel on a certain frequency

•Channel Name: Here you can fill in the name of the TV channel

3.Search for the frequency of the TV channel you are looking for (e.g. 471,25 MHz) on the channel overview chart of your Cable TV provider.

4.Look for the CableLink 75 channel number with a frequency which is near to the frequency you are looking for (chart in the back of this manual)

5.Look in the column CableLink 75 channel nr. Enter this number via the numeric (0..9) keyboard of the remote control.

6.Press FINE TUNE + when you search for a higher frequency. Hold the key until the text changes to "Fine tune +"

OR

Press FINE TUNE – when you search for a lower frequency. Hold the key until the text changes to "Fine tune –"

7.After a short time the TV channel will appear. Press the CBL ADD/DEL key to store the TV channel you found into the memory (press CBL ADD/DEL again if you want to remove the TV channel from the memory again).

8.Repeat steps 3 to 7 to add all TV channels to the memory of the CableLink 75

6.4. Clearing the memory (master reset)

1.Switch the CableLink 75 transmitter off and on again (by using the ON/OFF switch (7)).

2.Press the SOURCE and CHAN DOWN key (middle key) at the front of the transmitter at the same time

3.On screen the text "DELETED" will appear

7. Universal remote 5in1

The provided 5in1 remote does not only contain keys for your CableLink 75 system (read 5.4), you are also able to control your TV, VCR, DVD player and Satellite receiver with it! The remote is pre-programmed at the factory for most brands and models of equipment.

10 MARMITEK