The remote won’t work with the CableLink 75
1.The code of the remote is not matching the code setup in the CableLink system.
2.To operate the CableLink with the remote provided, you need to point it at the CableLink receiver.
3.To operate the CableLink with the remote provided, it has to be set to the CableLink mode. To set it to the CableLink mode, press the [CBL] key.
4.Using a wireless baby monitor, wireless headphones or wireless speakers that operate on the same frequency as the infrared extender of your CableLink 75 (433 MHz) will significantly decrease the range.
5.After the CableLink transmitter has been turned on, you will get a blue screen showing the text "HANDSET CODE 636 etc.". If you wait too long to confirm, the set will not automatically switch to installation mode. To access the installation mode, you will then need to turn the CableLink transmitter off and on again.
My CableLink 75 cannot find any channels
1.The automatic search method only finds what are known as "whole" channels. However, some cable networks only use + and – channels. You can find these by searching for them manually.
I do not get the blue screen on my TV
1.The CableLink receiver is attached to the Scart input on your TV. This means that the TV always has to be set to "external channel" or "audio/video" channel. The instructions for your TV will tell you how to do this.
I’ve programmed the channels on the CableLink but I can't switch channels
1.Read "The remote won't work with the CableLink 75"
2.The CableLink has stored the channels in the transmitter. You therefore cannot switch channels on the TV; you have to do so on the CableLink transmitter itself. The TV therefore has to always be set to the "external" or "audio/video" channel. By setting the remote to CableLink mode (using the [CBL] key), you can change the channels on the CableLink transmitter. When doing so, it is important to aim at the CableLink receiver.
I can't change the order of the channels
1.The CableLink uses a standard order for the channel numbers. You cannot change that
order yourself.
I can hear the sound of the first TV on the second TV via the CableLink.
You probably connected the cable with the Scart adapter TRANSMITTER to the audio/video OUT of the CableLink transmitter. You need to use OUTPUT with the Scart adapter RECEIVER or INPUT with the Scart adapter TRANSMITTER.
CABLELINK | 15 |
