Marshall electronic NCB-1004 System Configuration, Remote Control with Image Video Pass-Through

System Configuration (continued)

Remote Control with Image Video Pass-Through

■Overview

Use the following configuration for basic remote control of Marshall IMD series monitors, while also passing through Image Video protocol. This setup allows remote control of the IMD monitor, and pass-through of Image Video text and tally commands from an Image Video TSI-1000 or other Image Video protocol source.

■Wiring Diagram

Image Video TSI-1000 Tally Controller (Or other Image Video Protocol Source)

PC

Ethernet Cable to

Network Connection

on NCB-1004

Network

Use second RS-422 jack on each monitor to

daisy-chain multiple monitors.

NCB-1004

Connect monitors to RS-422 Outputs on Marshal IMD Monitors. Use up to 4 RS-422 outputs on NCB-1004.

Use 6P6C Modular Cable, wired pin-to-pin.

Connect up to 128 IMD screens per RS- 422 output

Marshall	Marshall
IMD	IMD

Marshall	Marshall
IMD	IMD

Marshall	Marshall
IMD	IMD

Marshall	Marshall
IMD	IMD

Marshall	Marshall
IMD	IMD

Marshall	Marshall
IMD	IMD

■Monitor Configuration

The following settings are required on each IMD monitor:

IMD Protocol:	MEI-Image Video
IMD Baud Rate:	57600
ID#:	Each monitor’s ID# will be set automatically by Image Video controller.
IMD Name (S/N):	Each monitor must have a unique string in this field.

In this configuration, Pass-Through must be set to “ON” and to “Image Video” in the OSD Configuration & IMD Page of the web interface. See page 19 for details.

14