Handles and TOP Cover, Battery | Master Lock MGH6500IE, MGH3000G

PORTABLE GASOLINE GENERATORS

HANDLES AND TOP COVER

(Model MGH10000A)

Follow the steps below to attach the handles and top cover to Model MGH10000A:

1.Remove the two bolts, lock nuts, and washers holding side panels to control panel end of roll cage. Insert bolts with washers through two holes in the handle and then back through roll cage and side screen panels (See Figure 8). Tighten the lock nuts against the side screen panels.

2.Place top cover on top of generator roll cage with notch on control panel side. Use four #8 sems screws provided to attach cover to roll cage (See Figure 9).

Roll Cage

Bolts Washers

Handle	Lock Nuts

Figure 8 – Attaching Handles to Roll Cage

SEMS Screws

Top Cover

SEMS

Screws

Figure 9 – Attaching Top Cover to Roll Cage

BATTERY

(Models MGH5000DIE, MGH6500IE, and MGH10000A)

WARNING: Battery gives off explosive gases. Keep sparks, flames, and cigarettes away. Do not remove or install battery cables when engine is cranking or running. Only service or use battery in a well-vented area.

WARNING: Battery contains sulfuric acid. Contact with skin or eyes may cause severe burns. Do not tilt generator with battery installed. Tilting could cause bat- tery acid to spill. Wear protective clothing and face shield when servicing. Keep out of children’s reach.

•If battery acid gets on your skin, wash with water.

•If battery acid gets in your eyes, flush with water at least 15 min- utes. Call a doctor at once. Battery acid is poisonous.

•If swallowed, drink large amounts of water or milk. Fol- low with milk of magnesia or vegetable oil. Call a doctor at once.

CAUTION: If you remove bat- tery, insulate the red, positive (+) battery cable terminal. Insulate with electrical tape. Exposed ter- minal may spark when generator runs.

IMPORTANT: Make sure battery connec- tions are the correct polarity. Electric start generators use negative ground, 12-volt DC starting system.

Models MGH5000DIE, MGH6500IE, and MGH10000A have an electric starter. A battery is not supplied with generator. You must provide a 12-volt, 32-amp-hour bat- tery. The positive and negative battery cables are supplied with generator. You must in- stall these cables before mounting battery.

Always wear safety glasses when working with battery. Make sure battery terminals are clean. Make sure cable connections are tight.

Always shut down engine before removing or attaching battery cables. Always remove the negative (–) cable first. Always attach negative (–) cable last.

INSTALLING BATTERY CABLES TO ENGINE

1.Attach the red, positive (+) battery cable to the starter solenoid on engine (see Figure 10). The starter solenoid is located directly above the starter on Model MGH10000A. This cable is fac- tory installed.

CAUTION: Do not over tighten positive terminal on starter sole- noid. Positive terminal could ro- tate and cut into negative termi- nal, causing a short.

2.Attach the black, negative (–) battery cable to the engine block. Use the bolt, nut, and two washers provided with the battery cables. Use long mounting hole on oppo- site side of engine from starter solenoid. Attach cable as shown in Figure 11.

Starter

Solenoid

Red, Positive (+)

Battery Cable

Figure 10 - Connecting Red, Positive (+) Battery Cable to Engine Starter Solenoid (Model MGH6500IE Shown)

Black,

Negative (–)