Operating your Matrox 4Sight-M unit 21
Operating your Matrox 4Sight-M unit
The following points should be considered when operating your Matrox 4Sight-M
unit.
Light emitting diodes (LEDs)
There are a total of six clearly labelled LEDs on the Matrox 4Sight-M unit.
• On one side, there are four LEDs:
- On (topmost LED). The Power-on LED lights up when the unit is on.
- User (second LED). The User-defined LED is currently teserved for future use.
-Diagnostics (third LED). The Diagnostic LED flashes according to a
pre-determined pattern to communicate POST errors. See the BIOS referenc e
appendix for details on interpreting the flash codes.
- HDD (bottom LED). The Hard disk drive LED lights when the hard disk is
working.
• On the opposite side, there are four network LEDs:
- 100 Mbps (yellow LED). The 100 Mbps LED light when the networking
interface is in 100BaseT mode. This LED shuts off when the network interface
is in 10BaseT mode.
- Activity (green LED). The Activity LED for the 100 Mbps network interface
lights when the unit is connected to a network and blinks during data transfers;
this LED shuts off when there is no connection present.
- GbE (100/1000 bicolor LED). The Gigabit Ethernet LED lights yellow when
the networking interface is using the 100BaseT Ethernet network connection;
the LED lights green when the networking interface is using the 1000 Gigabit
Ethernet network connection. This LED shuts off when the unit uses the
10BaseT connection.
- Activity (green LED). The Activity LED for the GbE network interface lights
when the unit is connected to a network and blinks during data transfers. This
LED shuts off when there is no connection present.
MATROX IMAGING est distribué par TECHWAY - www.techway.fr - info@techway.fr - +33 (0)1 64 86 58 30