INSTALLATION AND CONNECTION

4. Connecting & Running WDR-516S

4.1. Connecting camera

(1)Connect CCTV camera to WDR-516S with BNC cable as shown below.

(2)Set video type (NTSC/PAL) by rear panel’s switch.

<Note>

The video type for all channels should be either NTSC or PAL. NTSC is the standard used in North America.

(3) Set the impedance control switch for each channel as needed.

<Note>

It may be necessary to configure impedance of video input differently for each channel. For more detailed information, please refer to “Video type / impedance setup switch” in Appendix #2.

CAMERA

REMOTE

CONTROL

Hi-Z N ON

1 2 3 4 P OFF

WDR-516S Installation Guide

11

Rev 1.0(93/11)

Page 11
Image 11
Maxtor manual Connecting & Running WDR-516S, Connecting camera