26. Directions for reversingthe dryer door:
1.Removethe hinge hole covers and screws. Move the door catchcover to the oppositeside.
2.While supportingthe door, remove4 screws in the hinges that secure the hinges to the cabinet and set the door down.
3.Move the following parts to the opposite side of the door: 2 hinges and 4 hinge screws, 4 door screws, door strike and screw, inner door cover plate and screw.
4.Attach the door to the opposite side of the cabinet using the 2 counter sunk hinge screws. (See figure 58.)
5.Replace the hinge hole coversto the opposite side.
|
|
| Door Catch | Counter | Sunk Screw |
| ||
|
|
| _ |
| ' | Door | ||
| /" | _', |
|
| _" | _ | ||
| I" | ""I 1 | , |
|
|
|
| strka, |
| t | _,, | Cover | Coy | , |
|
|
|
| x | _+ |
|
|
|
| ||
|
|
|
|
| _ | Screws | ||
Figure 58 | '" ,, | _/[/ |
|
|
|
|
|
|
27. Directions for reversing the washer door:
1.Swing door fully open and support it while removing four hingescrews (which hold hinges to door assembly).
2.Set door asideand transferfour colormatcheddoor screws to the oppositeside of the door assembly.
3.Remove one screw holding top hinge to cabinet and one screw holding top hingecover to cabinet
(oppositeside).
4. Remove hinge and bracketfrom cabinet by moving them up and down to a positionwhere they are released.
5.Install hinge and bracket in swapped locations and drive screws to attach them securelyto the cabi- net.
6. Comparetop hinge and top bracketto bottom hinge and bottom bracket for correct assembly posi- tion.
7.Repeat procedures4 through 6 for bottom hinge to cabinet and bottom bracket to cabinet.
8.Support door in fully open position on hinge side and drive four screws to secure attach hinges to door assembly.
9. Close door and check to see that clotheswasher operates properly.
Counter Sunk Screw_,
// | / / '/"_" |
|
|
| Door |
|
|
|
|
| Screws |
f | _1 | 7it | Hole | I | ng |
| I t | I_t | Covers |
|
|
,,,,!,\ |
|
| +++ | Door |
_ | _ "_ + _' | _ | Screws |
Figure 59
Page 23
