|
| |
Removethe terminalblockcoverplate. |
| |
|
| |
Insertthe powercordwithan agencylistedstrainrelief | (" | _ |
throughtheholeprovidedin the cabinetneartheterminal | _ | o |
block. Note,a strainreliefmustbe used. | __ |
|
Do notloosenthe nutsalreadyinstalledonthe terminal | Neutral |
|
|
|
|
block. Be suretheyare tight. Use a 3/8 inchdeep well | Pos"t | o | o |
| Power |
|
|
| Cord | ||
socket. |
|
|
|
| Ground |
support using the ground screw. (See figure 30.) |
|
|
|
|
|
If the power cord has terminals, place the terminals over |
|
|
| _;eJ | ,Wire |
Secure the power cord ground wireto the terminal block |
|
|
| ||
the existing nuts on the posts. The neutral wire in power |
|
|
|
|
|
cord must be connectedto the center (silver colored |
|
|
|
| Power |
|
|
|
|
| cord |
post of the terminal block. | Neutral |
| o | _. • and | |
Securein place using the nuts providedin the parts |
|
|
| (" Ah JF"/- | strain |
usethe cuppedwashers ahead of the nuts. |
|
|
|
|
|
package. If the power cord does not have terminals | Figure 30 |
| f |
| relief |
Be sure the terminal block nuts are tight. Securethe |
|
|
|
| |
power cord in position. Tightenthe strain relief screw(s) |
|
|
|
|
|
in orderto clamp the strain reliefto the cord. |
|
|
|
|
|
Replace the terminal block cover. |
|
|
|
|
|
BEFORE OPERATINGOR TESTING, be sure the machine is properly grounded.
EXPORT GAS MODELS
Export gas models are manufacturedfor operationon either 230/240 volt, 50 Hz or 220 volt, 60 Hz AC approvedelectrical service with a 15 ampere fuse or circuit breaker.
Export gas models have been manufacturedfor use with natural gas having a higher heatingvalue of approxi- mately 1025 BTU per cubic foot. Conversion to LP gas with a higher heating value of approximately2500 BTU per cubic foot must be performed by a qualified service technician. A conversion kit is available.
For electric dryers in alcove installation:
MAKING SURE FIRST THAT OUTLET IS NOT ENERGIZED,plugpowercordfor dryerintoan outletpriorto
lifting dryer ontowasher.
13. Makesure that the exhaust seal is in place and evenwith the end of the exhaust pipe. (See figures 31 & 32.)
Figure 31 | Figure 32 | Figure 33 |
Make sure front tabs are not bent, use screwdriverto straightentabs if bent. (See figure 33.)
Page 16
