Maytag 700 manual Care & Cleaning, Cleaning Procedures, Part, display area

Care & Cleaning

Cleaning Procedures

CAUTION

•Be sure appliance is off and all parts are cool before handling or cleaning. This is to avoid damage and possible burns.

•To prevent staining or discoloration, clean appliance after each use.

•If a part is removed, be sure it is correctly replaced.

*Brand names are registered trademarks of the respective manufacturers.

**To order call 1-877-232-6771 USA and

1-800-688-8408 Canada.

PART	PROCEDURE
Burner Caps and	Removable Burner Caps
Sealed Gas	•	Allow burner to cool. Remove burner cap and wash in soapy water with a plastic scouring pad. For
Burners		stubborn soils, clean with a soap-filled, nonabrasive pad or Cooktop Cleaning Creme*
		(Part #20000001)** and a sponge.
	•	Do not clean in the dishwasher or self-cleaning oven.
	Sealed Gas Burners
	•	Clean frequently. Allow burner to cool. Clean with soap and plastic scouring pad. For stubborn soils,
		clean with a soap-filled, nonabrasive pad. Do not enlarge or distort holes.
	•	Be careful not to get water into burner ports.
	•	Use care when cleaning the ignitor. If the ignitor is wet or damaged the surface burner will not light.
Burner Grates -	•	Wash with warm, soapy water and a nonabrasive, plastic, scrubbing pad. For stubborn soils,
Porcelain on		clean with a soap-filled, nonabrasive, plastic pad or Cooktop Cleaning Creme* (Part #20000001)**
Cast Iron		and a sponge. If soil remains, reapply Cooktop Cleaning Creme, cover with a damp paper towel and soak
		for 30 minutes. Scrub again, rinse and dry.
	•	Do not clean in the dishwasher or self-cleaning oven.
Clock and	•	To activate control lock for cleaning, see “Locking the controls” page 9.
Control Pad	•	Wipe with a damp cloth and dry. Do not use abrasive cleaning agents as they may scratch the finish.
Area	•	Glass cleaners may be used if sprayed on a cloth first. DO NOT spray directly on control pad and
		display area.
Control Knobs	•	Remove knobs in the OFF position by pulling forward.
	•	Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish.
	•	Turn on each burner to be sure the knobs have been correctly replaced.
Cooktop and	Porcelain enamel is glass fused on metal and may crack or chip with misuse. It is acid resistant, not acid proof.
Control Panel -	All spillovers, especially acidic or sugary spillovers, should be wiped up immediately with a dry cloth.
Porcelain Enamel	•	When cool, wash with soapy water, rinse and dry.
	•	Never wipe off a warm or hot surface with a damp cloth. This may cause cracking or chipping.
	•	Never use oven cleaners, abrasive or caustic cleaning agents on exterior finish of range.
Side Panels,	•	When cool, wash with warm soapy water, rinse and dry. Never wipe a warm or hot surface with a damp
Storage Drawer		cloth as this may damage the surface and may cause a steam burn.
and Door	•	For stubborn soil, use mildly abrasive cleaning agents such as baking soda paste or Bon Ami*. Do not use
Handles -		abrasive cleaners such as steel wool pads or oven cleaners. These products will scratch or permanently
Painted Enamel		damage the surface.
	Note: Use a dry towel or cloth to wipe up spills, especially acidic or sugary spills. Surface may
	discolor or dull if soil is not immediately removed. This is especially important for white surfaces.

20 cont.