Maytag 8113P448-60 Electrical Connection, Removal of Gas Appliance, Storage Drawer select models

Maintenance

Electrical Connection

Appliances which require electrical power are equipped with a three- prong grounding plug which must be plugged directly into a properly grounded three-hole 120 volt electrical outlet.

Always disconnect power to appliance before servicing.

The three-prong grounding plug offers protection against shock hazards. DO NOT CUT OR REMOVE THE THIRD GROUNDING PRONG FROM THE POWER CORD PLUG.

If an ungrounded, two-hole or other type electrical outlet is encountered, it is the personal responsibility of the appliance owner to have the outlet replaced with a properly grounded three-hole electrical outlet.

Removal of Gas Appliance

Gas appliance connectors used to connect this appliance to the gas supply are not designed for continuous movement. Once installed, DO NOT repeatedly move this gas appliance for cleaning or to relocate. If this appliance has to be moved and/or removed for servicing, follow the procedure described in the installation instructions. For information, contact Customer Assistance at 1-800-688-1120 USA and Canada.

To prevent range from accidentally tipping, range must be secured to the floor by sliding rear leveling leg into the anti- tip bracket.

the two tabs on the burner assembly into the two slots on the burner support bracket which is mounted to the burner bottom. (NOTE: If the tabs are not properly inserted into the slots, the assembly may rock and the burners may not light properly.)

Storage Drawer (select models)

CAUTION

Do not store plastic, paper products, food or flammable materials in this drawer. The drawer may become too warm for these items when the oven is in use.

The storage drawer can be removed to allow you to clean under the range.

To remove:

1.Empty drawer and pull out to the first stop position.

2.Lift up the front of the drawer.

3.Pull out to the second stop position.

4.Grasp sides and lift drawer up and out.

To replace:

1.Fit the ends of the drawer glides into the rails in the range.

2.Lift up the front of the drawer and gently push in to the first stop position.

3.Lift drawer up again and push until drawer is closed.

Conventional Surface Burners

(select models)

Under no circumstances are the surface burner assemblies to be taken apart for cleaning. The surface burner assembly can be removed to clean the burner box area.

Freestanding range only:

The two surface burner assemblies are secured in place during transportation with screws. Once the range is installed, these screws may be removed to allow quick and easy removal of the burner assemblies.

To remove:

Allow the burner assembly to cool. Lift up cooktop. Grasp the burner assembly and rotate it slightly toward the left to release the two tabs on the assembly. Then lift the assembly and pull toward the back of the cooktop until the air shutter ends on the assembly release from the valves.

To replace:

Insert the air shutter ends on the burner assembly over the valves and lower the assembly into place. Be sure to secure

Oven Bottom

Protect oven bottom against spillovers, especially acidic or sugary spills, as they may discolor the porcelain enamel. Use the correct pan size to avoid spillovers and boilovers.

The oven bottom may be removed for easier cleaning.

To remove:

When cool, remove the oven racks. Slide the two
catches, located at each rear corner of
the oven bottom, toward the front of the	1
oven.
	2
Lift the rear edge of the oven bottom
slightly, then slide it back until the front
edge of the oven bottom clears the	3
oven front frame. Remove oven bottom
from oven.

To replace:

Fit the front edge of the oven bottom into the oven front frame. Lower the rear of the oven bottom and slide the two catches back to lock the oven bottom in place.

24