3.Make a complete operational check of ALL safety related circuits:
a.Door Switch(es)
b.
c.Sail Switch - Gas Models
NOTE: To check for proper sail switch operation (for Gas Models), open the main door and while holding main door switch plunger in, start dryer. The dryer should start but heat circuit should not be activated (on). If the heat system is activated, the sail switch is improperly adjusted and must be adjusted by bending the actuator arm of the sail switch toward the burner box. If the actuator arm is bent too far toward the burner box of the dryer, the dryer may not have heat when needed. After any adjustment to the sail switch, the above procedure must be repeated to verify proper operation of the sail switch.
4.The dryer should be operated through one (1) complete cycle to assure that no further adjustments are necessary and that ALL components are functioning properly.
BASKET COATING
The basket (tumbler) is treated with a protective coating. We suggest dampening old garments or cloth material with a solution of water and nonflammable mild detergent and tumbling them in the basket (tumbler) to remove this coating.
5.Make a complete operational check of ALL operating controls.
a. For microprocessor controller (computer) model check programs/selections...
1)Each microprocessor controller (computer) has been preprogrammed by the factory with the most commonly used parameter (program) selections. If computer program changes are required, refer to the computer programming manual which was shipped with the dryer.
6.Check the electric service phase sequence
IMPORTANT: If the blower wheel (impellor and fan) is rotating in the wrong direction, this will not only drastically reduce drying efficiency, but it can also cause premature component failure.
31
