Ice and Water

Warm Cabinet Surfaces Ice and Water

that the light levels in the room are low. Setting 1 is the darkest light level setting, setting 9 is the brightest light level setting. Important: The Auto Light must be activated on the ice and water dispenser control to take advantage of this option.

Sabbath Mode (SAb)

When the Sabbath Mode is on, all control lights, interior lights, night light, ice and water dispenser and alarm tones will be disabled until the feature is turned off. Press the Door Alarm pad for three seconds to restore the lights.

Notes:

Dispenser light will not activate during dispensing while in Sabbath Mode.

If the power fails, the control will remain in Sabbath Mode when power returns.

Warm Cabinet Surfaces

At times, the front of the refrigerator cabinet and the vertical hinged section of the door may be warm to the touch. This is a normal occurrence that helps prevent moisture from condensing on the cabinet. This condition will be more noticeable when the refrigerator is first started, during hot weather and after excessive or lengthy door openings.

Note: During initial use of water dispenser and ice maker, there will be a one to two minute delay while water tank fills before water dispenses or ice is made. Discard first 10-14 glasses of water after initially connecting refrigerator to household water supply. Additional flushing may be required in some households where water is of poor quality.

Ice and Water Dispenser

To Use Dispenser Paddle:

• Choose Water selection from dispenser control panel.

• Press a sturdy, wide-mouthed container against dispenser paddle.

• Dispenser Light will come

Water

 

on while paddle is pressed.

Dispenser

Cube

• Release pressure on

 

 

addle

 

 

P

 

dispenser paddle to stop

 

 

water dispensing. A small

Removable Tray

amount of water may

continue to dispense and collect in dispenser tray. Large spills should be wiped dry.

Removable Tray

The removable tray at the bottom of the dispenser area is designed to collect small spills and may be easily removed for cleaning and emptying purposes.

Important: Removable tray does not drain. Do not allow tray to overflow. If it does, remove tray and wipe up overflow.

To Dispense Ice and Water:

Select Water or Cube ice mode by pushing button on dispenser control panel. A green light above button indicates mode selection.

Press container against dispenser paddle. When dispensing ice, hold container as close to chute as possible to reduce spraying.

Note: If dispenser is active for more than five minutes, an automatic lock out sensor will shut down power to dispenser area. See Dispenser Lock/Unlock for unlocking information.

Dispenser Lock/Unlock

The Dispenser Lock/Unlock affects all keypad functions.

To Lock Dispenser:

Press and hold the Lock/Unlock button for three seconds. A green indicator light above the button will illuminate when the dispenser is locked.

To Unlock Dispenser:

Hold the Lock/Unlock button for three seconds. The green indicator light above will go out.

Automatic Ice Maker

Connect the ice maker to the water supply as instructed on pages 8-9. A properly leveled refrigerator is essential for optimal ice maker production.

Ice Storage Bin

The ice storage bin is

 

located below the automatic

ON/OFF

ice maker in the upper left

side enclosure of the fresh

switch

 

food compartment.

 

To Remove:

 

• Depress the button on the lower right of the ice

storage bin to release from the enclosure. Ice and Water Dispenser Continue pulling until resistance is felt. Lift up front of ice bin and remove. Press the switch on the front

of the ice maker to turn the ice maker off.

12

Page 13
Image 13
Maytag MFI2266AEW Ice and Water Dispenser, Automatic Ice Maker, Warm Cabinet Surfaces, Ice Storage Bin, addle