Maytag MFI2266AEW Handles, Plastic Handle, Freezer Handle, Installation

Installation

To Install:

1. Pull both rails out to full extension.

2. While supporting door front, hook supports into slots located on inside of each slide.

Note: All four drawer bracket supports must be in the proper slots for the drawer to function properly. (See inset for detail.)

3.Lower door front into final position.

4.Replace and tighten Phillips screws that were

removed from the drawer slides.

5. Install the lower assembly by aligning hooks of lower drawer assembly with rear rail on freezer drawer.

6.Replace freezer bins. Align the large square notches

on outside of the drawer slides.

Handles

Note: If not installed, the handle is located in the interior of the fresh food compartment or attached to the back of your refrigerator.

Plastic Handle

To Remove:

1. Grasp the lower part of the handle firmly, slide up, lift and remove from the surface.

ToInstall: 1. The handles are to be oriented as

shown.

2. Align door handle clip with the door studs.

3. Ensure the large hole in the mounting clip is positioned down on both ends of the handle.

4. Rotate the handle so that the handle is flat against the door.

5.Grasp the handle firmly and slide down.

Freezer Handle

Notes:

•Select models have a slight curve to the freezer handle.

•For proper installation, be sure

handle is oriented as shown.

Door Stud

7