Maytag MFI2266AEW Fresh Food Features, Spill-CatcherTM Glass Shelves

Fresh Food Features

Shelves

CAUTION

To avoid personal injury or property damage, observe the following:

•Never attempt to adjust a shelf that is loaded with food.

•Confirm shelf is secure before placing items on shelf.

•Handle tempered glass shelves carefully. Shelves may break suddenly if nicked, scratched, or exposed to sudden temperature change.

Spill-CatcherTMGlass Shelves

Your refrigerator has Spill-CatcherTMglass shelves. The shelves have a spill retainer edge which allows for easier clean up and some are equipped with a slide out feature. To slide out, grasp the front of the shelf and pull forward. Push in the shelf to return to the original position.

To Remove a Shelf:

• Slightly tilt up the front and lift up the rear of the shelf, then pull the shelf straight out.

To Lock the Shelf Into Another

Position:

•Tilt up the front edge of the shelf.

•Insert the hook into the desired frame openings and let the shelf settle into place.

•Be sure the shelf is securely locked at the rear.

Elevator™ Shelf (select models)

The Elevator™ Shelf is equipped with a spill-retaining edge and the EasyGlide™ slide-out feature. It can be adjusted up or down without unloading.

To Slide Out EasyGlide™ Shelf:

•Grasp the front of the shelf and pull forward.

•Push the shelf in to return to original position.

To Adjust the Elevator™ Shelf:

•Pull out the knob on the crank handle.

•Rotate the crank clockwise to raise the shelf, and counterclockwise to lower the height of the shelf.

To Remove Elevator™ Shelf:

•Completely unload the shelf and pull the shelf forward.

•Pull until the shelf stops.

•Slightly tilt up the front and pull the shelf straight out. Continue pulling forward until the shelf is clear of the frame.

To Replace Elevator™ Shelf:

•Align the shelf to the frame and push it all the way back.

In ordinary use, the Elevator™ Shelf frame assembly does NOT require removal. Though unlikely, and not recommended, the correct removal procedure is as follows:

To Remove Frame Assembly:

•Unload the shelf completely.

•Slide the shelf forward about 2” and manually move the two rear latches toward the shelf center.

•While supporting the entire shelf and frame from underneath, lift slightly and rotate the assembly approximately 30° to allow the rear mechanism to clear the vertical rear side rails.

•The entire assembly can then be moved forward and clear of the refrigerator compartment.

To Reinstall Frame Assembly:

•Reverse the removal procedure. Be sure the shelf is in a level position. When the sliding shelf is pushed to the rear, it will reposition the rear latches to their correct operating position.

Latches (style may vary)

Slide Out

EasyGlideTM Shelf

16