240EdwardsStreet.SE
Cleveland,Tennessee37311
Cut appropriate lengths of tape to be applied above the top chromed endcap and below the bottom chromed
endcap on both doors. Strips will also have to be placed on either side of the handle trim extension just below
the top chromed handle endcap and just above on the bottom endcap on both the freezer and refrigerator doors.
7.Place a handle retainer insert in the open area of each handle (dispenser models will only have one for the
refrigerator door). If any panel color can be seen at the comers, reposition the black tape previously installed.
Some amount of bow may be present in the insert but if bow is excessive when the insert is installed, remove
it. Carefully file the ends until the insert still fits snug but bow has been reduced to a minimum.
HA_DL£ ,_E'rAJ_Ee TA_
J
TAP£
INSTALLATIONOF REFRIGERATORDECORATIVEPANEL
NOTE: Remove protective film from finish side of perimeter trim lengths before proceeding to install them. Discard.
INSTALLATION OF FILLER STRIP
8. Peel back three to four inches of the protective backing and crease to form pull tab on the end of the filler strip that will be placed towards the top of the refrigerator door.
PROT_'T]V£
./_ I_AC_ FOAM.
FILL£;_End Toward
_TRIP | Tug Of Door |
9.Position filer strip with "soft nose" against handle side on the left side of the door. apply pressure to the "hard end" of the filler strip to slightly compress the soft nose against band e. Then press down firmly to
insure proper bonding.
PULL [
TAB '\ TOP OF DOOR
F =_..__...____=n.te
1 ,, | End Cap |
\Press Slightly To
:Comnre__s"Soft Nose"
i
PressDo%)_T,)a _nsure
